Authors

Abstract

The main purpose for designing and constructing electroradio frequency linear accelerators is to reach better beam quality with higher power and energy by lower RF power consumption. The main step for this purpose is doing research and development in the area of designing, constructing, measuring and tuning of accelerator RF cavities. Institute for Research in Fundamental Sciences (IPM) linear accelerator projecta is the first Iranian project for construction of electrolinear accelerator. In this paper, a brief introduction to construction procedure has been given. Then, the measurement and tuning of a disk-loaded periodic structure before and after tuning was reported. In addition, the detailed design and measurement setup for electric field measurement by perturbation method was investigated

 

Keywords

1. R F Post and N S Shiren, Review of Scientific Instruments, 26 (2) (1955) 205.
2. M Chodorow, E L Ginzton, W W Hansen, R L Kyhl, R B Neal, and W K H Panofsky, Stanford High‐Energy Linear Electron Accelerator (Mark III). Review of Scientific Instruments, 26 (2), (1955) 134.
3. J Gao, Analytical approach and scaling laws in the design of disk-loaded travelling wave accelerating structures. Paris-11 Univ., 91-Orsay (France). Lab. de l'Accelerateur Lineaire (1993). .
4. T P Wangler, “RF Linear accelerators”, John Wiley & Sons (2008).
5. W Fang, D Tong, Q Gu, and Z Zhao, Design and experimental study of a C-band traveling-wave accelerating structure. Chinese Science Bulletin, 56 (1), (2011) 18.
6. G A Loew, R H Miller, R A Early, and K L Bane, Computer calculations of traveling-wave periodic structure properties. Stanford Univ., CA (USA) (1979).
7. W Fang, Q Gu, D Tong, and Z Zhao, Design optimization of a C-band traveling-wave accelerating structure for a compact X-ray Free Electron Laser facility. Chinese Science Bulletin, 56 (32) (2011) 3420.
8. L C Maier Jr, and J C Slater, Journal of Applied Physics, 23(1), (1952) 78.
9. C W Steele, IEEE Transactions on, 14(2), (1966) 70.
10. S Ghosh, S Seth, A Mandal, and S S Som, Bead-pull measurement using phase-shift technique in multi-cell elliptical cavity. In Conf. Proc. 110904, IPAC-2011-MOPC088, (2011) 280.
11. L C Maier Jr, and J C Slater, Journal of Applied Physics, 23 (1), (1952) 68.
12. W J Gallagher, “Measurement techniques for periodic structures,” Microwave Lab., Stanford Univ., Stanford, CA, Rep. 767, (1960).

ارتقاء امنیت وب با وف ایرانی