Authors

Abstract

  We have initiated a study to extract concentration profiles of ultra shallow phosphorous implants in silicon complementing published work on ultra shallow boron implant profiles. There is an ever-increasing interest in the production of p-n junctions in silicon to create the new generations of ultra large scale integrated (ULSI) devices. Such junctions can be formed by implantation do pants (such as B, P, and As) at lowered energies. Development of design tools and process implementation both require that accurate methods be available for confirming absolute do pant profiles. Traditionally, profiles have been extracted through the use of secondary ion mass spectroscopy (SIMS), Rutherford backscattering spectroscopy (RBS), nuclear reaction analysis (NRA) and electrical measurements such as spreading resistance profilometry. Results of ion implanted species can be checked by SIMS (J.G.M. van Berkum, et al Vac. Sci. Technol. B16 (1998) 298). However, the analysis of ultra shallow implants by standard SIMS techniques is not straightforward and is weak in quantitative measurements. There are several reasons for this. First, standard methods of SIMS are hampered by limits on the instrumental sensitivity, which may not be adequate to examine very low-dose implants. Second, the accuracy in quantifying standard SIMS at very shallow depth is limited, due to an initial transitional region within which the sample composition equilibrates with the primary ion beam. This initial equilibration is characteristic of the SIMS technique, and is highly reproducible. Considerable effort has been expended in understanding the details of the equilibrium process, nevertheless, it is complicated even in the simplest of situations and continues to present problems for accurate quantification. Third, in specific situations high mass resolution required to separate the species of interest, or its proxy, from other mass groups, including impurity groups. Although there has been many investigations to extract quantitative profiles by SIMS using relative sensitivity factors (RSF), they can be reproduced 20-30% under more controlled conditions (R.G. Wilson, S.W. Novak, J. Appl. Phys. 69 (1991) 466). However, there is a need for other methods to normalize SIMS results.   RBS is a candidate to calibrate SIMS profiles, but lacks the sensitivity to detect phosphorous due to the proximity of its mass with the masses of Si isotopes. Nuclear reaction analysis (NRA), 31P( a ,p)34S, is a suitable method for phosphorous detection. This nuclear reaction displays a resonance in the cross section at an incident energy near 5 MeV. While the cross section for the 31P( a ,p)34S reaction is small, we are able to measure the absolute do pant concentration of phosphorous implants into Si down to fluences of 1 ´ 1014cm-2. This opens a route to the calibration of TOF SIMS integrated profiles for P, which may then be used for analysis of the lower fluence regime. Two sets of phosphorous implanted silicon wafers were prepared. Phosphorous doses in our samples ranged from 1 ´ 1013 cm-2 to 5 ´ 1015 cm-2 with the implanted energy of 1 keV to 30 keV. To date, no evidence was found for self-sputtering based on these samples.   The alpha capture reaction on phosphorous has been investigated in the field of nuclear physics to find the nuclear energy level of different isotopes. This reaction has been used in profiling P in silicon, but none to P concentrations and P implanted energies as low as those reported here. The present studies complement the work done on ultra shallow boron implant (Aditya Agarwal, et al Appl. Phys. Lett. 74 (1999) 2453).

Keywords

ارتقاء امنیت وب با وف ایرانی