Design and construction of a pre-injector for the Iranian Light Source Facility

Sadeghipanah, A; Sarhadi, KH; Rahighi, J

doi:10.18869/acadpub.ijpr.15.2.183

Design and construction of a pre-injector for the Iranian Light Source Facility

Authors

A Sadeghipanah

KH Sarhadi

J Rahighi

https://doi.org/10.18869/acadpub.ijpr.15.2.183

Abstract

Every synchrotron accelerator requires a pre-injector for primary injection of the electrons into the booster ring. The Iranian Light Source Facility (ILSF) pre-injector is a 150 MeV S-band linear accelerator with a thermionic cathode RF gun. The design of the pre-injector lattice and its beam dynamics calculation results together with the design of RF gun, alpha magnet, quadrupole magnets and linear accelerator structures are described in this article. The measurement results of the RF gun prototype fabricated in Iran demonstrate a dimension error less than 20 μm and a surface roughness of less than 0.8 μm

Keywords

pre-injector

RF electron gun

beam dynamics

alpha magnet

1. H Ghasem et al., Journal of Instrumentation, 8 )2013(.
2. J H Billen and L M Young, \"Poisson\'s Superfish Manual\", Los Alamos National Laboratory, USA )2006(.
3. \"CST Microwave Studio Tutorial\", CST GmbH )2006(.
4. Michael Borland, “Summary of Equations and Methods Used in SPIFFE”, APS/IN/LINAC/92-2, USA, June )1992(.
5. L C Maier and J C Slater, Journal of Applied Physics, 23 )1952(.
6. \"RADIA Documentation\", ESRF )2006(.
7. Michael Borland, “ELEGANT: A Flexible SDDS-Compliant Code for Acceleration Simulation”, Advanced Photon Source LS-287, USA, September )2000(.